Troubleshooting - Ryobi RY907000FI Manual Del Operador

Generador 7 000 watts
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

PROBLEM
Engine will not start.
Engine hard to start.
Engine lacks power.
Electric start feature not working.
AC receptacle does not work.
Generator makes a "spark knock" or
"pinging" noise.
If problem persists after trying the above solutions, contact customer service or a qualified service center for assistance.
NOTICE:
As the equipment owner, you are responsible for the performance of the required maintenance listed in the Maintenance
section. It is recommended that you retain all receipts covering maintenance on your equipment. Neglecting or failing
to perform the required maintenance may increase emissions, decrease fuel efficiency, degrade performance, cause ir-
reversible engine damage and/or void your warranty.

TROUBLESHOOTING

POSSIBLE CAUSE
Battery not charged.
Check engine indicator light is on.
Engine switch is OFF.
No fuel.
Stale gasoline or water in gasoline.
Lubricant level is low.
Fuel valve is OFF.
Spark plug faulty, fouled, or improperly
gapped.
Engine stored without treating or
draining gasoline, or refueled with bad
gasoline.
Dirty fuel filter.
Water in gasoline.
Weak spark at spark plug.
Dirty air filter.
Check engine indicator light is on.
Engine stored without treating or
draining gasoline, or refueled with bad
gasoline.
Battery wires are disconnected.
Battery is not charged.
Engine battery charge circuit fuse is
blown.
Circuit breaker is tripped.
GFCI is tripped.
Item plugged in is defective.
An occasional light "knocking" or "ping-
ing" under heavy load is not a cause for
concern. However, if the knocking or
pinging occurs under normal load at a
steady engine speed, the problem may
be with the brand of gasoline being used.
Page 19 — English
SOLUTION
Charge battery.
Contact a qualified service center.
Turn engine switch to ON.
Fill fuel tank.
Drain entire system and refill with fresh
fuel.
Engine is equipped with Low Oil Shutoff.
If engine lubricant level is low, it must be
filled before unit will start. Check engine
lubrincant level and fill, if necessary.
Turn fuel valve ON.
Replace spark plug.
Drain fuel. Refuel with fresh gasoline.
Replace fuel filter or contact a qualified
service center.
Drain entire system and refill with fresh
fuel.
Replace spark plug or contact a quali-
fied service center.
Check air filter element. Clean or replace
as needed.
Contact a qualified service center.
Drain fuel. Refuel with fresh gasoline. If
problem continues, contact a qualified
service center.
Connect the battery wires.
Charge the battery.
Replace the engine battery charge
circuit fuse.
Reset the AC circuit breaker.
Reset the GFCI.
Try a different item.
Switch to a different brand of gasoline,
making sure that the octane rating is 86
or higher. If problem continues, contact
a qualified service center.

Publicidad

Tabla de contenido
loading

Tabla de contenido