Technical Specifications Of Product - Nice Hyke HK7024 Instrucciones Y Advertencias Para La Instalación Y El Uso

WARNINGS: • All technical specifications stated in this section refer to an ambient temperature of 20°C (± 5°C). • Nice S.p.a. reserves the right to apply modifica-
tions to products at any time when deemed necessary, maintaining the same intended use and functionality.
Type
Maximum torque
Nominal torque
Speed under no load
Maximum cycle frequency
Maximum continuous cycle time
Application limits
Lifetime
Power supply
Backup power supply
Solar power
Maximum absorbed power
Maximum absorbed current
Absorbed power with "All –
Standby" function when powered
by PS124 or SYKCE kit (including
OXI receiver)
Flashing light output [*]
Electric lock output [*]
Gate open indicator output [*]
BLUEBUS output
STOP input
SS input
Radio engage
Radio AERIAL input
Programmable functions
Functions in self-learning
Assembly
Operating temperature
Se in acid, saline or potentially
explosive atmospheres
Protection rating
Dimensions (mm)
Weight (kg)
[*] - The outputs Flashing Light, Electric lock and Gate Open Indicator can be programmed with other functions (see "TABLE 3 – Level 1 functions"; or via the Oview programmer; see
chapter 8.3). The electrical specifications of the output are adapted to the type of selected function: • flashing light function: lamp 12 Vdc, max. 21 W; • electric lock function: 12 Vac
max. 15 VA; • other outputs (all types): 1 lamp or relay 24Vdc (-30 to +50%), max. 4 W.

TECHNICAL SPECIFICATIONS OF PRODUCT

HK7024K
Electromechanical gearmotor for automations of gates and
automatic doors with DC motor, epicyclical gear reducer and
mechanical release. Built-in control unit and OXI radio receiver.
1.5 RPM
the product can be used on the product can be used on
gates with leaf weights up gates with leaf weights up
to 330 kg or with lengths to 270 kg or with lengths
up to 3.5 m up to 3 m
estimated between 150,000 cycles and 500,000 cycles, according to the conditions stated in table 13 and graph 3
230 Vac ±10%; 50/60 Hz
provision for buffer battery PS124
provision for SYKCE kit
300 W
1,5 A (3 A for version HK7024K/V1)
less than 100 mW
one LUCYB flashing light (12 V, 21 W bulb)
one 12 Vac electric lock (max 15 VA)
one 24 V lamp (max. 4 W) (the output voltage may vary betwe-
en -30 and +50%, the output can also control small relays)
one output with load of maximum 15 Bluebus units (max.
6 pairs of MOFB or MOFOB photocells plus 2 pairs of
MOFB or MOFOB photocells routed as opening devices
plus max. 4 MOMB or MOTB control devices)
for normally closed contacts, normally open contacts or
contacts with constant 8,2 kΩ resistance; selection of the
type of contact is in self-learning mode and a modifica-
tion with respect to the memorised status will generate
a "STOP"
for normally open contacts (closure of the contact genera-
tes a Step Step command)
SM connector for receivers in the families SMXI, OXI and
OXIFM
50 Ω for cable type RG58 or similar
8 ON-OFF type functions (Table 3) and 8 settable fun-
ctions (Table 5)
• Self-learning of devices connected to the BlueBus
output. • Self-learning of the type of device connected to
the "STOP" terminal (NO, NC contact or 8,2 kΩ resistan-
ce). • Self-learning of the gate leaf travel and automatic
calculation of deceleration points and partial opening. •
Self-learning of operation with one or two motors
from -20°C to +50°C (at low temperatures, gearmotor efficiency is reduced)
10.5
HK7024KHS HK7224K
Electromechanical gearmotor for automations of gates
and automatic doors with DC motor, epicyclical gear
reducer and mechanical release.
500 Nm
120 Nm
2 RPM
40 cycles/hour
approx. 7 minutes
the product can be used on
gates with leaf weights up
to 330 kg or with lengths
up to 3.5 m
Vertical, with dedicated fixing plate
NO
IP 54 (with container intact)
210 x 290 x 320 h
HK7224KHS
1.5 RPM 2 RPM
the product can be used on
gates with leaf weights up
to 270 kg or with lengths
up to 3 m
24 Vdc (±10%)
140 W
6 A for a maximum interval of 2 s
9.5
English – 13