Kenwood DNN992 Guia De Inicio Rapido página 23

Ñ Removing the trim plate
1) Engage the catch pins on the extraction key
(accessory3) and remove the two locks on the
lower level.
Lower the trim plate (accessory8) and pull it
forward as shown in the figure.
3
✎
NOTE
• The trim plate can be removed from the top side in
the same manner.
2) When the lower level is removed, remove the
upper two locations.
8
Catch
Lock
Ñ Removing the unit
1) Remove the trim plate by referring to step 1 in
"Removing the trim plate".
2) Insert the two extraction key (accessory3)
deeply into the slots on each side, as shown.
3) Lower the extraction key toward the bottom,
and pull out the unit halfway while pressing
towards the inside.
✎
NOTE
• Be careful to avoid injury from the catch pins on the
extraction key.
4) Pull the unit all the way out with your hands,
being careful not to drop it.
3
23
English ñ