Lower Anchor Installation; Lap-Shoulder Belt Installation; Lap Belt Installation; Attaching The Infant Car Seat - Britax ENDEAVOURS B-SAFE ULTRA Guia Del Usuario

Britax Child Safety, Inc.

Attaching the Infant Car Seat

1. Ensure that the base is
securely installed.
2. Place the infant car seat
into the base and press
down until a click is heard.
3. Pull up on one side and
then the other of the infant
car seat to ensure that it is
attached securely.
4. Ensure that the carry
handle is in one of the
four locked positions and
check that the recline
angle is still correct.

Removing the Infant Car Seat

1. Pull and hold the release
lever on the back of the
infant car seat.
2. Lift the infant car seat up
from the base.
18
ENDEAVOURS/B-SAFE ULTRA User Guide

Uninstalling the Base

Lower Anchor Installation

1. Press the lower connector
release button on the top
of the base to loosen the
straps.
2. Press each of the red
release buttons on the
lower connectors and
release vehicle anchors.
3. Store the lower connectors in the storage slots in the
base until reinstalling. Pull on the lower connector straps
in center of base to remove slack.
Lap Shoulder Belt Installation
1. Unbuckle the vehicle belt
and remove from the lock-
off. Pull the belt from the
base belt routes.

Lap Belt Installation

1. Unbuckle the vehicle belt
and pull the belt from the
base belt routes.
19