This guide contains abbreviated "Quick Reference" procedures for the
FixAssist® Diagnostic Tool. Please visit www.innova.com to download
Retrieve Codes
Connect the Diagnostic Tool to the vehicle's test connector.
Turn the ignition key "On." DO NOT start the engine.
The tool will automatically link to the vehicle's computer.
View Results
The Diagnostic Tool retrieves stored codes, Freeze
Frame data and System Status.
Codes, I/M Monitor Status and Freeze Frame data are
displayed on the Diagnostic Tool's display screen. System
Status is indicated by LED indicators.
If a recommended solution for the "priority" DTC is
available, the FixAssist® screen for the DTC displays. The
screen shows recommended inspection and repair actions
to correct the malfunction that caused the DTC to be set.
If more than one DTC was retrieved, press and release
the DTC/FF button, as necessary. Freeze Frame Data (if
available) will be displayed after the Priority Code by
pressing the DTC/FF button.
In the case of long code definitions, or when viewing
Freeze Frame Data, use the UP
buttons, as necessary, to view the additional information.
To view OEM Enhanced DTCs (if available), press the
SYSTEM
OEM Enhanced mode provides the ability to retrieve OEM
enhanced DTCs, Anti-Lock Brake System (ABS) DTCs
and Supplemental Restraint System (SRS) DTCs from
most Chrysler/Jeep, Ford/Mazda, GM/Isuzu, Honda/Acura
and Toyota/Lexus vehicles.
Perform Additional Tests
While linked to a vehicle, press the M button. The Main
Menu displays. Use the UP
necessary, to highlight System Tests, then press the
ENTER
button. The System Test Menu displays. Use
the UP
highlight the desired option, then press the ENTER
button.
You can use the Diagnostic Tool to perform additional diagnostic tests (O2 Sensor
Test, OBD Monitor Test, EVAP Leak Test).
a copy of the complete Owner's Manual.
button; the System menu displays. The
and DOWN
and DOWN
and DOWN
buttons, as necessary, to
1
as