Cleaning And Care - Unold 48870 Instrucciones De Uso

17. During operation, you can change the duration of operation by setting the
desired time via the rotary knob. If you turn the knob to the left, the time
will be shortened in 1-minute increments, if you turn the knob to the right,
the time will be extended in 1-minute increments. The minimum prepara-
tion time is 5 minutes, shorter times cannot be set.
18. After expiration of the set time the appliance automatically switches off and
a signal beeps ten times. The display shows 00:00.
19. If the ice cream is not removed immediately after the program ends, after
ten minutes the automatic keep-cool phase switches on. After a few min-
utes, the compressor will be heard for a short time.
Remove ice cream
20. Before removing the ice cream from the appliance, switch off the appliance
with the POWER switch and unplug the power cord from the electrical out-
let.
21. Remove the transparent lid.
22. Remove the ice cream bowl from the appliance and carefully pull the mixer
out of the bowl.
23. Transfer the ice cream to a suitable bowl. Do not use sharp or pointed
objects for this; instead, use a plastic or wooden spoon in order not to dam-
age the ice cream bowl. We recommend using a silicone dough scraper.
24. If desired, you can make more ice cream right away. In this case, start again
with step number 1.
25. Tip: If you make fruit ice cream or sorbet, remove the ice cream bowl as
soon as the program is finished, transfer the ice cream to a bowl suitable for
freezing and put this bowl in the freezer so that the ice cream freezes com-
pletely. Otherwise, this ice cream may be slightly soft inside, even if it is
firmly frozen on the outside.
26. If you do not wish to make more ice cream, switch the appliance off with the
POWER switch and unplug it from the electrical outlet.

CLEANING AND CARE

Before cleaning, always turn off the appliance, unplug it from the electrical
outlet and allow the appliance to cool.
1. Never clean the appliance with or under water or other liquids. It is espe-
cially important to keep the motor and the compressor from coming into
contact with water.
Stand 29.7.2020
Copyright UNOLD AG | www.unold.de
DE
EN
FR
NL
IT
ES
PL
31 von 112