How To Assemble Your Ceiling Fan - Fanimation AIREDROP LP8069 Serie Manual Del Usuario

1. Remove the hanger ball
hanger ball assembly by loosening the set screw in the
hanger ball until the ball falls freely down the downrod.
Remove the pin from the downrod, then remove the
hanger ball. Retain the pin and hanger ball for reinstal-
lation in Step 6. (Figure 1)
2. Remove the hairpin clip and clevis pin from the
bottom of the downrod. Retain the pin and clip for
reinstallation in Step 4. (Figure 2)
3. Route the black, white and blue wires through the
downrod. (Figure 3)
4. Thread downrod into the downrod support on top of
the motor. Install the clevis pin by aligning the holes
in the downrod support with holes in the downrod.
Secure clevis pin with hairpin clip. Reinstall and tighten
the two set screws with nuts, removed in step 2 of
How to Assemble Your Ceiling Fan Blades, in the
downrod support. (Figure 4)
WARNING
It is critical that the clevis pin in the downrod support
is properly installed and the set screws and nuts are
securely tightened. Failure to do so could result in
the fan falling.

How to Assemble Your Ceiling Fan

portion from the downrod/
Downrod
Hanger Ball
Hairpin Clip
Downrod
Set Screws and
Locking Nuts (2)
9
Pin
Set Screw
Figure 1
Clevis Pin
Figure 2
Black, White and
Blue wires
Downrod
Figure 3
Hairpin Clip
Clevis Pin
Figure 4