Install The Chute-Rotation Box; Install The Chute Deflector; Install The Battery Pack; Remove The Battery Pack - GreenWorks Pro 2602502 Manual Del Operador

EN
6.4 INSTALL THE CHUTE-ROTATION
BOX
23 24
19
1. Align the holes in the panel of the chute-rotation box
(23) and the switch box (24).
2. Put the chute-rotation box screws (18) through the
holes.
3. Tighten the chute-rotation box screw nuts (19) with
a wrench (not included).
6.5

INSTALL THE CHUTE DEFLECTOR

18
1. Align the grooves (26) of the discharge chute with
the slot (25) on the chute housing.
2. Push the discharge chute (7) into position.
3. Tighten the discharge chute screws (18) with a
Phillips head screw driver to lock the discharge
chute.
6.6

INSTALL THE BATTERY PACK

18
7
26
25
5
20
21
English
• If the battery pack or charger is damaged, replace
the battery pack or the charger.
• Stop the machine and wait until the engine stops
before you install or remove the battery pack.
• Read, know, and follow the instructions in the
battery and charger manual.
1. Open the battery door (5).
2. Align the ribs on the battery pack (20) with the
grooves in the battery compartment.
3. Push the battery pack (20) into the battery
compartment until the battery pack (20) locks into
place.
4. When you hear a click, the battery pack (20) is
installed.
5. Close the battery door (5).
6.7

REMOVE THE BATTERY PACK

1. Open the battery door (5).
2. Push and hold the battery release button (21).
3. Remove the battery pack (20) from the machine.
7

OPERATION

Wear eye protection during operation.
7.1

COLD WEATHER OPERATION

The safe battery operation temperature ranges from 1°F
(-17°C) to 113°F (45°C).
Do not store or charge battery outside.
Battery must be charged and stored indoors prior to use
of the machine.
If the machine does not start below 1°F (-17°C),
• remove the battery pack from the machine,
• charge the battery pack for 10 minutes in warm
area, or when the charging light turns green.
• Install the battery pack again.
8
WARNING
WARNING
WARNING