Replace The Belt; Replace The Impeller; Replace The Skid Plates - GreenWorks Pro 2602502 Manual Del Operador

WARNING
The scraper is located at the bottom of the impeller
housing. Ensure that the battery is not installed in the
tool.
1. Turn the machine to its side.
2. Remove the 5 bolts (17) below the deck that attach
the scraper (9) to the machine.
3. Remove the worn scraper (9) from the machine.
4. Install the new scraper (9).
5. Install and tighten the bolts (17) that you removed.
8.3

REPLACE THE BELT

18 27
29 28
WARNING
Make sure to turn off the bail lever and remove the
battery pack(s) before performing any maintenance
task on your snow thrower.
1. Remove the screws (18) on the side wear pad (27).
2. Turn the large pulley (29) counterclockwise while
you remove the remaining belt (28).
3. Turn the new belt (28) onto the pulleys (29).
4. Install and tighten the screws (18) that you removed.
English
8.4

REPLACE THE IMPELLER

10
Make sure to turn off the bail lever and remove the
battery pack(s) before performing any maintenance
task on your snow thrower.
1. Remove the 4 sets of nuts and bolts on the middle
steel plate.
2. Remove the 4 sets of nuts and bolts on each side.
3. Remove the impellers (10).
4. Install the new impellers (10).
5. Tigthen the 8 sets of nuts and bolts that you
removed.
8.5

REPLACE THE SKID PLATES

17 30
31 19
The range of adjustable height for skid plates is
1.5mm, when putting the bolts through the U-hole on
the skid plates.
1. Loosen the 2 sets of bolts (17), spacers (31) and
nuts (19) that attach the skid plates (30) to the snow
thrower housing.
2. Remove the skid plates (30).
3. Install the new skid plates (30).
4. Do the same operation on the other side.
11
WARNING
NOTE
EN