Husqvarna GT48XLSi Manual De Operario página 8

KNOW YOUR TRACTOR
READ THIS MANUAL AND SAFETY RULES BEFORE OPERATING YOUR TRACTOR
Compare the illustrations with your tractor to familiarize yourself with the locations of various controls and ad just ments.
Save this manual for future reference.
B
A
M
Our tractors conform to the applicable safety standards of the American National Standards Institute.
(A) ATTACHMENT LIFT LEVER - Used to raise and
lower mower or other attachments mounted to tractor.
(B) BRAKE PEDAL - Used for braking the tractor and
starting the engine.
(C) PARKING BRAKE - Locks clutch/brake pedal into the
brake position.
(CC) PARKING BRAKE SYMBOL - Indicates a starting
fault when the parking brake is disengaged.
(D) THROTTLE CONTROL - Used to control engine speed.
(E) ATTACHMENT CLUTCH SWITCH - Used to engage
mower blades or other attachments mounted to tractor.
(EE) BLADE SWITCH SYMBOL - Indicates a fault when
the attachment clutch switch is engaged.
(F) S S IGNITION (SSI) BUTTON - Used for
MART WITCH
starting/stopping engine and communicating status up-
dates.
(G)* REVERSE OPERATION SYSTEM (ROS) - Allows
operation of mower deck or other powered attachment
while in reverse.
(H)* HEADLIGHT BUTTON - Turns the headlights on/off.
OPERATION
P
D
Q
C
Z
J
Fig. 3
(I)* BATTERY INDICATOR BUTTON - Used to indicate
low battery voltage or a charging system fault.
(J) CRUISE CONTROL LEVER - Used to set forward
movement of tractor at desired speed without holding the
forward drive pedal.
(K) FORWARD DRIVE PEDAL - Used for forward move-
ment of tractor.
(L) REVERSE DRIVE PEDAL - Used for reverse move-
ment of tractor.
(M) FREEWHEEL CONTROL - Disengages transmission
for pushing or slowly tow ing the trac tor with the engine off.
(P) HOURMETER - Indicates hours of operation.
(Q) 12-VOLT POWER PORT - Used for 12 volt accessories.
(S) BATTERY INDICATOR/CHARGING PLUG - Indi-
cates the status of the battery.
(Y) DIFFERENTIAL LOCK SWITCH - Used to engage
and disengage the differential lock on transaxle.
(Z) AMMETER - Indicates charging (+) or discharging (-)
of battery.
* NOTE: G, H, and I are also used as the numerical input buttons
for entering the passcode.
8
S
Y
F
CC
E
K
I
H
L
EE
G