Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

(1) Oil Drain Tube
Your new tractor has been assembled at the factory with the exception of those parts left unassembled for shipping purposes.
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set will make assembly easier. Stan dard
wrench sizes are listed.
(1) 1/2" wrench
(2) 7/16" wrenches
When right or left hand is mentioned in this man ual, it means
when you are in the operating po si tion (seated be hind the
steer ing wheel).
TO REMOVE TRACTOR FROM CARTON
UNPACK CARTON
Remove all accessible loose parts and parts cartons
from carton.
Remove end panels and lay side panels flat.
Check for any additional loose parts or cartons and
remove.
BEFORE REMOVING TRACTOR FROM
SKID
TO CHECK BATTERY (See Fig. 1)
Lift hood to raised position.
NOTE: If this battery is put into service after month and
year indicated on label (label is located between terminals)
charge battery for minimum of one hour at 6-10 amps.
(See "BATTERY" in Maintenance section of this manual
for charging instructions).
For battery and battery cable installation see "RE-
PLACING BATTERY" in the "Service and Adjustments"
section in this manual.
LABEL
UNASSEMBLED PARTS
(1) Quick Connect

ASSEMBLY

Tire pressure gauge
Utility knife
Fig. 1
Slope Sheet
ADJUST SEAT (See Fig. 2)
Sit in seat.
Lift up adjustment lever (A) and slide seat until a com-
fortable position is reached which allows you to press
clutch/brake pedal all the way down.
Pliers
Release lever to lock seat in position.
NOTE: You may now roll your tractor off the skid. Continue
using the instructions that follow to remove the tractor from
the skid.
WARNING: Before start ing, read, un der stand and fol-
low all in struc tions in the Op er a tion section of this man u al.
Ensure tractor is in a well-ventilated area. Ensure the area
in front of tractor is clear of other peo ple and objects.
TO ROLL TRACTOR OFF SKID
Op er a tion section for location and function
of con trols)
Raise attachment lift lever to its highest po si tion.
Release parking brake by de press ing brake ped al.
Place freewheel control in dis en gaged po si tion to
dis en gage trans mis sion (See "TO TRANS PORT" in
the Op er a tion section of this manual).
Roll tractor forward off skid.
Continue with the in struc tions that follow.
5
*Installed by Dealer
*Brush Guard Kit
*Pedal
(2) Screw
(2) Nut
U-Channel
A
Fig. 2
(See

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido