Samsung NX58 565 Serie Manual Del Usuario página 61

WARNING
Do not spray any type of cleaner into the manifold panel holes. Within these
holes are ignition switches which carry the current that lights the surface burners.
Spraying into them could damage the range.
Oven racks
• If the racks are left in the oven during a self-cleaning cycle, their color will
turn slightly blue and the finish will be dull. After the self-cleaning cycle is
complete and the oven has cooled, rub the sides of the racks with wax paper
or a cloth containing a small amount of oil. This will help the racks glide more
easily into their tracks.
• Gliding racks may be cleaned by hand with an abrasive cleaner or steel wool.
During cleaning, be careful not to allow water or cleaner to enter the slides on
the sides of rack.
NOTE
• Do not clean in a dishwasher.
• If the rack becomes hard to remove or replace, lightly wipe the oven rack
guides with cooking oil. Do not wipe cooking oil on the slides.
• If the rack becomes difficult to slide, the rack may need to be lubricated using
Graphite Lubrication.
1. Wipe off any spills with a damp, soft
cloth.
2. Apply an approved stainless steel
cleaner to a damp, clean cloth or paper
towel. Clean a small area carefully
following the instructions on the
cleaner. Stainless steel should always be
cleaned with the grain in the stainless
steel, if applicable.
3. Dry and buff with a clean, dry, soft
cloth.
4. Repeat steps 2 and 3 as necessary.
NOTE
• To order Graphite Lubrication, call our customer center at
1-800-SAMSUNG (726-7864) or visit our homepage
(www.samsung.com/us/support, www.samsung.com/ca/support (English) or,
www.samsung.com/ca_fr/support (French)) and reference DG81-01629A.
• If you want to buy directly, visit our on-line parts distributor at
http://www.samsungparts.com/Default.aspx.
To lubricate the slides
1. Remove the rack from the oven. See
removing the gliding rack in the Using
the gliding rack section.
2. Fully extend the rack on a table or
countertop. Newspaper may be placed
underneath the rack for easy cleanup.
3. If there is debris in the slide tracks,
wipe it away using a paper towel.(Any
graphite lubricant wiped away must be
replaced - See steps 4 through 7.
English 61