Weighing With Pre-Tare - Seca 656 Manual De Instrucciones

Weighing with pre-Tare

If the pre-Tare function is activated, a stored weight value is deducted from the currently
measured weight. This function is useful, for example, if the weight of a wheelchair is not
to be displayed.
Three different tare weights (wheelchair weights) can be stored..
– Press the Start key with no load on the
scale.
,
se(a 8. 8 . 8 . 8 . 8 .
secutively in the display. The scale is
then automatically set to zero and ready
for operation.
– Press the FUNC key.
The last function used appears in the
display.
– Use the arrow keys to select the pre-
Tare function FU 3.
function by pressing the FUNC key
once again.
The last memory used appears in the
display.
An arrow on the left-hand side of the
display also indicates which memory is
set.
– Use the arrow keys to select the desired
memory for storing the additional
weight or where a weight may already
be stored.
– Press the FUNC key again. In the dis-
play you will see the tare value from the
memory.
– You can use the arrow keys to adjust
the value in increments according to the
graduations displayed.
– Once the correct value is set, press the
FUNC key again. The pre-Tare function
is now activated.
– Move onto the scale in the wheelchair
associated with that memory. Read the
weighing result off the digital display.
– To return to normal weighing mode,
press the FUNC key.
– To switch off the scale, press the Start
key again.
Tip: note weight and the memory in which the weight is stored on your wheel-
chairs.
24
and appear con-
0. 0
Activate the