Supported Formats; Power Supply - Bresser GameCamera Instrucciones De Uso

1.5 Supported formats

Here are some important notices. You don't need to
worry about the fi le system format of the camera unless
you have problems with reading the SD-card with your
other equipment. If this happens, please format the
SD-card in the camera or in a computer fi rst and then
reinsert the card into your camera to make a try.
Item
Image
Video
File format
2 Caution!
• The working voltage of the camera is 6V. The camera
is supplied by four AA batteries.
• Please install batteries according to shown polarity.
• For camera operation an SD-card (8 MB to 32 GB)
is needed.
• Please unlock the write-protect before inserting the
SD-card.
• Please insert the SD-card when the power switch is at
Format
JPG
AVI
FAT32
OFF position before testing the camera. The camera
has no internal memory for saving images or videos.
• Please do not insert or take out the SD-card when the
power switch is at ON position.
• It is recommended to use the camera to format the
SD-card when used for the fi rst time.
• The camera will be in USB mode when connected to
a USB port of a computer. In this case, the SD-card
functions as a removable disk.
• In the TEST mode (insert the control into the USB
interface then switch the camera at ON position), the
camera will shut down automatically after 3 minutes if
no operation is done. Please turn on the power again if
you want to continue to work with the control.
• Please ensure suffi cient power when having fi rmware
upgrade, otherwise the upgrade process could
be interrupted incorrectly. If any fault occurs after
improper upgrading process, the camera may stop
function properly.
3. Main operations

3.1 Power supply

To supply power for the camera, four AA size batteries
are needed.
GB
25