SOUNDMASTER Highline FUR6005 Instrucciones De Montaje Y Seguridad página 16

Dimmer control
In standby mode, press the dimmer (13) button allows you to set the brightness of the LED
display to high, medium, low 3 levels.
NAP timer function (count down timer)
During radio off mode, press the NAP button (6), to turn on the NAP mode, the NAP time will
keep by 5 seconds, within 5 seconds and press NAP button (6) button can change the duration
from 90 min – 10 min.
The alarm buzzer will sound for 30 min and then shut off automatically. To stop the alarm
buzzer, press the ON/OFF button (14).
Press the NAP button (6) has no effect during alarm operation. Press ON/OFF button (14) to
cancel NAP function.
Projection unit
-
Focus setting: Adjust the projection clock brightness/focus by turning the brightness/focus
adjustment wheel unit the projected time is clearly shown on the ceiling or wall.
- Adjust projected direction.
-
To flip projected image by 180°, press PROJECTION TIME 180° FLIP button (4).
NOTE: PROJECTS TIME IMAGE ON THE CEILING OR WALL OF A DARKENED ROOM.
MAXIMUN PROJECTION DISTANCE IS 3-9 FEET.
IMPORTANT
There is a sensor located on top of the unit that picks up any movement or objects near the top
or back of the unit. Please be sure to place the radio on a surface with a no obstructions 9-12
inches above or 3-6 inches behind the unit. This will help maximize the area for recognizing the
motion of your hand and also reduce the chances of the unit false triggering. If the unit begins
beeping and the display functions erratically, it may be either too close to an object above or
behind the unit. If this happens, please make sure there are 9-12 inches of clearance above and
3-6 inches behind the unit to avoid the false triggering.
INFRARED SENSOR FUNCTION
1. In radio off mode, to display alarm time settings :
Wave your hand over the IR SENSOR (1) again within 1 second to show the ALARM 1 time.
5
FUR6005 / English Instruction Manual