Briggs & Stratton BPW3200 Manual Del Operario página 6

warning Fuel and its vapors are extremely flammable and explosive which
could cause burns, fire or explosion resulting in death,
serious injury and/or property damage.
wHen adding or draining FueL
• Turn pressure washer engine OFF and let it cool at least 2 minutes before
removing fuel cap. Loosen cap slowly to relieve pressure in tank.
• Fill or drain fuel tank outdoors.
• DO NOT overfill tank. Allow space for fuel expansion.
• If fuel spills, wait until it evaporates before starting engine.
• Keep fuel away from sparks, open flames, pilot lights, heat, and other ignition
sources.
• Check fuel lines, tank, cap and fittings frequently for cracks or leaks. Replace if
necessary.
• DO NOT light a cigarette or smoke.
wHen starting eQuiPMent
• Ensure spark plug, muffler, fuel cap, and air cleaner are in place.
• DO NOT crank engine with spark plug removed.
wHen oPerating eQuiPMent
• DO NOT operate this product inside any building, carport, porch, mobile
equipment, marine applications, or enclosure.
• DO NOT tip engine or equipment at angle which causes fuel to spill.
• DO NOT spray flammable liquids.
wHen transPorting, Moving or rePairing eQuiPMent
• Transport/move/repair with fuel tank EMPTY or with fuel shutoff valve OFF.
• DO NOT tip engine or equipment at angle which causes fuel to spill.
• Disconnect spark plug wire.
wHen storing FueL or eQuiPMent witH FueL in tank
• Store away from furnaces, stoves, water heaters, clothes dryers, or other
appliances that have pilot light or other ignition source because they could ignite
fuel vapors.
warning The high pressure stream of water that this equipment produces
could cut through skin and its underlying tissues, resulting in serious
injury and possible amputation.
Spray gun traps high water pressure, even when engine is stopped and
water is disconnected, which could result in serious injury.
• If cut by fluid, call physician immediately. DO NOT treat as a simple cut.
• DO NOT allow CHILDREN to operate pressure washer.
• NEVER repair high pressure hose. Replace it.
• NEVER repair leaking connections with sealant of any kind. Replace o-ring or seal.
• NEVER connect high pressure hose to nozzle extension.
• Keep high pressure hose connected to pump and spray gun while system is
pressurized.
• ALWAYS point spray gun in safe direction, press red button and squeeze spray
gun trigger to release high pressure, every time you stop engine.
• NEVER aim spray gun at people, animals, or plants.
• DO NOT secure spray gun in open position.
• DO NOT leave spray gun unattended while machine is running.
• NEVER use a spray gun which does not have a trigger lock or trigger guard in
place and in working order.
• Always be certain spray gun, nozzles and accessories are correctly attached.
warning Unintentional sparking could cause fire or electric shock resulting
in death or serious injury.
wHen adJusting or Making rePairs to your Pressure wasHer
• Disconnect the spark plug wire from the spark plug and place the wire where it
cannot contact spark plug.
wHen testing For engine sPark
• Use approved spark plug tester.
• DO NOT check for spark with spark plug removed.
6
warning Starter and other rotating parts could entangle hands, hair,
clothing, or accessories resulting in serious injury.
• NEVER operate pressure washer without protective housing or covers.
• DO NOT wear loose clothing, jewelry or anything that could be caught in the
starter or other rotating parts.
• Tie up long hair and remove jewelry.
warning Risk of eye or bodily injury.
Spray could splash back or propel objects resulting in serious
injury.
• Always wear indirect vented (chemical splash) safety goggles marked to comply
with ANSI Z87.1 when using or in vicinity of this equipment.
• NEVER substitute safety glasses or dry-condition goggles for indirect vented
safety goggles.
• Always wear protective clothing such as a long-sleeved shirt, long pants and
close-toed shoes.
• NEVER operate pressure washer when barefoot or wearing sandals or shorts.
caution Excessively high operating speeds could result in minor injury
and/or pressure washer damage.
Excessively low speeds impose a heavy load.
• DO NOT tamper with governor spring, links or other parts to increase engine
speed. Pressure washer supplies correct rated pressure and flow when running at
governed speed.
• DO NOT modify pressure washer in any way.
NOTICE High pressure spray may damage fragile items including glass.
• DO NOT point spray gun at glass when using red 0° spray tip.
• NEVER aim spray gun at plants.
NOTICE Improper treatment of pressure washer could damage it and shorten its life.
• If you have questions about intended use, ask dealer or contact qualified service
center.
• NEVER operate units with broken or missing parts, or without protective housing or
covers.
• DO NOT by-pass any safety device on this machine.
• DO NOT tamper with governed speed.
• DO NOT operate pressure washer above rated pressure.
• DO NOT modify pressure washer in any way.
• Before starting pressure washer in cold weather, check all parts of the equipment to
be sure ice has not formed there.
• NEVER move machine by pulling on hoses. Use handle provided on unit.
• This equipment is designed to be used with Briggs & Stratton Power Products
authorized parts ONLY. If equipment is used with parts that DO NOT comply with
minimum specifications, user assumes all risks and liabilities.
Briggsandstratton.coM