Tabla de contenido
Publicidad
ILUSTRACIÓN DE LOS REPUESTOS PARA DW2130
2
3
3
Para repuestos, visite www.campbellhausfeld.com
24 horas al día, 365 días al año
Por favor proporcione la siguiente información:
- Número de modelo
- Número de serie (si lo tiene)
- Descripción de la parte y número que le corresponde en la lista de partes
Sp14
4
5
1
BEFORE YOU BEGIN
Description
These Campbell Hausfeld wire feed welders are designed to be used on standard 115V outlets. The welder is
equipped with infinite wire speed control to accurately select the proper wire feed rate needed for various
welding conditions. Internal components are thermostatically protected.
The DW2130 is designed for use with the Flux Cored Arc Welding (FCAW) process. As delivered from the
factory, this welder can weld with .030 inch (0.8 mm) and .035 inch (0.9 mm) diameter flux core wires. A
starter spool of .030 inch (0.8 mm) flux cored wire is included.
UNPACKING
After unpacking the unit, inspect carefully for any damage that may have occurred during transit. Check for
loose, missing or damaged parts. Check to be sure all supplied accessories are enclosed with the unit. In case
of questions, damaged or missing parts, please visit www.campbellhausfeld.com for customer assistance.
Do not operate unit if damaged during shipping, handling or use. Damage may result in
bursting and cause injury or property damage.
Required Items - Not Included
•
Hand Shield
•
•
Chipping Hammer/Brush
•
•
Hex Wrench
•
•
Contact Tip 0.035 inch (0.9 mm)
GENERAL SAFETY INSTRUCTIONS
Safety Guidelines
This manual contains information that is very important to know and understand. This information is
provided for SAFETY and to PREVENT EQUIPMENT PROBLEMS. To help recognize this information, observe
the following symbols.
Danger indicates an imminently hazardous situation which, if not avoided, WILL result in death
or serious injury.
Warning indicates a potentially hazardous situation which, if not avoided, COULD result in
death or serious injury.
Caution indicates a potentially hazardous situation which, if not avoided, MAY result in minor or
moderate injury.
Notice indicates important information, that if not followed, may cause damage to equipment.
IMPORTANT or NOTE: Information that requires special attention.
Safety Symbols
The following Safety Symbols appear throughout this manual to alert you to important safety hazards and
precautions.
MANUAL
Risk of
Read
Risk of Shock
Risk of
Flying
Fire
Manual
Fragments
First
Risk of
Wear eye
Magnetism
protection
Hand Shield Lens
Flux Core Wire - 0.8 mm, 0.2 Kg Spool
Contact Tip 0.030 inch (0.8 mm)
Risk of
Risk of
Risk of
Risk of
Light Rays
Hot Parts
Explosion
Fumes
1
Publicidad
Tabla de contenido
