Delta ShopMaster S36-300 Manual De Instrucciones página 11

NOTE: Make sure that stand part 1 (H) and stand part 2 (I)
are assembled in the proper orientation.
With assembled stand open, attach legs (J) to the stand
using (eight) M8 x 35mm carriage bolts (a) and (eight) M8
lock nuts (e). Tighten lock nuts to secure legs to stand
(Fig. 3.)
NOTE: Do not over tighten lock nuts.
See finished assembly of stand in
NOTE: Before assembling stand to saw, unlock bevel
lock, tilt blade/motor assembly and remove Styrofoam
piece from under saw motor. The bevel lock is the handle
located underneath the blade height adjustment wheel
(Fig. 5).
ASSEMBLY
Fig. 4.
H
I
CORRECT
11
H
I
INCORRECT
FIGURE 2
J
e
FIGURE 3
FIGURE 4
FIGURE 5
a