Attaching Stand To Saw; Height Adjustment Knob Installation - Delta ShopMaster S36-300 Manual De Instrucciones

ATTACHING STAND TO SAW

Place saw (A) on stand assembly, while aligning the screw
holes in the saw stand with the threaded holes in the saw
base (Fig. 6).
Tighten hex cap screws to secure stand assembly to saw.
NOTE: Do not over tighten.
Saw as assembled (Fig. 7).
Refer to (Fig. 8).
Extend the outfeed support to expose the two holes. On
the bottom of the outfeed support tubes. Insert a M5 x
16 Phillips head bolt (i) from underneath. Tighten with
the supplied Allen wrench. Repeat on the other side of
outfeed support
.
HEIGHT ADJUSTMENT KNOB
INSTALLATION
• Insert shoulder screw (f) into height adjustment knob (g)
as shown in (Fig. 9).
• Tighten shoulder screw (f) with Phillips Screw driver
into Hand Wheel. Height adjustment knob should rotate
freely around shoulder screw when raising or lowering
the blade with the Height Adjustment Hand Wheel.
ASSEMBLY
A
f
12
FIGURE 6
FIGURE 7
i
FIGURE 8
g
FIGURE 9