Craftsman 247.883960 Manual Del Operador página 11

Chute Clean-Out Tool
A chute clean-out tool is fastened to the top of the auger housing
with a mounting clip. See Figure 11. The tool is designed to clear a
chute assembly of ice and snow. This item is fastened with a cable tie
at the factory. Cut the cable tie before operating the snow thrower.
WARNING
Never use your hands to clear a clogged chute assembly. Shut
off engine and remain behind handles until all moving parts have
stopped before using the clean-out tool to clear the chute assembly.
Drift Cutters
1. Remove the two screws and wing knobs that secure each drift
cutter, and remove them from the sides of the auger housing.
2. Turn the drift cutters around and position them as shown in Figure
12 to the outside of the auger housing.
3. Attach the drift cutters with the screws and wing knobs removed
earlier. See Figure 13.
Tire Pressure
WARNING
Under any circumstance do not exceed manufacturer's recom-
mended psi. Equal tire pressure should be maintained at all times.
Excessive pressure when seating beads may cause tire/rim
assembly to burst with force sufficient to cause serious injury. Refer
to sidewall of tire for recommended pressure.
The tires are over-inflated for shipping purposes. Check the tire
pressure before operating the snow thrower. Refer to the tire side wall
for tire manufacturer's recommended psi and deflate (or inflate) the
tires as necessary.
NOTE: Equal tire pressure is to be maintained at all times for perfor-
mance purposes.
Chute Clean-out Tool
Figure 11
ASSEMBLY
11
Figure 12
Figure 13