Maintenance And Cleaning - Oster 1693 Manual De Instrucciones

1. Set fan on a dry, level surface.
2. Plug cord into electric outlet. Please make sure the Speed Control Knob is in the off
position (O).
3. The speed is adjusted by turning the Control Knob to the desired setting, O-III-II-I.
4. The Oscillation Control Knob (
To start oscillation, push Control Knob down. To stop oscillation, pull Control Knob up.
Fan Head Tilt Adjustment
1. To change the tilting angle of the Fan Head, simply loosen the Tilt-Adjustment Knob.
2. Move the Fan Head to the desired angle and firmly tighten the Tilt-Adjustment Knob to
lock into place.

MAINTENANCE AND CLEANING

Follow these instructions to correctly and safely care for your table fan. Please
remember:
• Always unplug the fan before cleaning or disassembling
• Do not allow water to drip on or into the Fan Motor Housing
• Do not use any of the following as a cleaner: gasoline, thinner, benzene
(See instructions for fan head assembly)
1. To access the Fan Blade, remove the Front Grill and the Fan Blade Nut.
2. Clean the Fan Blade, both Front and Rear Grills with a soft cloth moistened with a mild
soap solution.
3. Replace Blade, tighten the Fan Blade Nut, and securely fasten the Front Grill.
FAN HEAD AND BASE CLEANING
Using a soft, moist cloth, with or without a mild soap solution, carefully clean the Fan
Base and Head. Please use caution around the Motor Housing area. Do not allow the
motor or other electrical components to be exposed to water.
When storing your fan in the off season, it is important to keep it in a safe dry location. It
is important to protect the fan head from dust. WE STRONGLY RECOMMEND USING
THE ORIGINAL BOX FROM PURCHASE.
OPERATING INSTRUCTIONS
ADJUSTMENT INSTRUCTIONS
FAN STORAGE
) is located on the top of the Fan Motor Housing.
4