Maintenance And Cleaning - Oster 1694 Manual De Instrucciones

1. Set fan base on a dry, level surface.
2. Plug cord into electrical outlet. Please make sure the Selector (Speed)
control is in the off position (O). The Selector (Speed) control is located on the top of
the Fan Motor Housing.
3. The Speed is adjusted by turning the control knob to the desired setting, O-III-II-I.
4. The Oscillation control knob (
To start Oscillation, push control knob down. To stop Oscillation, pull control knob up.
Fan Head Tilt-adjustment
1. To change the tilting angle of the fan head, simply loosen the Tilt-Adjustment Knob.
2. Move the fan head to the desired angle and firmly tighten the Tilt-Adjustment Knob to
lock into place.
REDUCED HEIGHT ADJUSTMENT
3. Remove the lower extension pole for reduced height.

MAINTENANCE AND CLEANING

Follow these instructions to correctly and safely care for your fan. Please remember:
• Always unplug the fan before cleaning
• Do not allow water to drip on or enter into fan housing
• Be sure to use a soft cloth moistened with a mild soap solution
• Do not use any of the following as a cleaner: gasoline, thinner, or benzene
Clean the fan grill, housing and base with a soft, damp cloth. DO NOT ATTEMPT TO
REMOVE THE FAN BLADE. Please use caution around the motor housing area. Do not
allow the motor or other electrical components to be exposed to water.
When storing your fan in the off season, it is important to keep it in a safe dry location. It
is important to protect the fan head from dust. WE STRONGLY RECOMMEND USING
THE ORIGINAL BOX FROM PURCHASE.
OPERATING INSTRUCTIONS
) is located on the top of the Fan Motor Housing.
ADJUSTMENT INSTRUCTIONS
FAN CLEANING
FAN STORAGE
4