Operation - Cameo TRIBAR 400 IR Manual De Usuario

OPERATION

After the spot has been correctly connected to the mains, the display briefly shows the software version (v1xx) and the spotlight is ready for
use and starts in the mode that was previously selected.
SELECTING DMX MODE
Press the MODE button repeatedly until one of the five DMX modes appears on the display (2CH, 3CH1, 3CH2, 9CH, 12CH). Use the UP and
DOWN buttons to select the desired DMX mode. You will find tables with the channels of the different DMX modes in this manual under DMX
Control.
SELECTING THE DMX START ADDRESS
Press the MODE button repeatedly until the DMX start address appears on the display (A001 - A512). Using the UP and DOWN buttons, the
DMX start address can now be set as desired from 001 to 512. The synchronous control of multiple spotlights (same model) through a DMX
control unit (e.g. DMX mixer) can be achieved by assigning the spotlights to an identical DMX start address and connecting them using DMX
cables.
INTERNAL PROGRAMS PG00 - PG12
Press the MODE button repeatedly until one of the 13 internal programs PG00 - PG12 appears on the display.
COLOUR MACROS AND STROBE PG00
Using the UP and DOWN buttons, select the PG00 program. To change the colour, press ENTER and select one of the 7
available colours or blackout by using the UP and DOWN buttons.
Colour Macros
C--0
C--1
C--2
C--3
Confirm with ENTER. The display now shows "FSxx" and you can use the UP and DOWN buttons to add a strobe effect to the previously selected
colour. (FS00 = strobe effect disabled, FS01 = minimum strobe speed, FS99 = maximum strobe speed). Once the desired stroboscope effect
has been set, press ENTER to confirm the input.
COLOUR CHANGE PROGRAMS AND STROBOSCOPE PG01 - PG12
Using the UP and DOWN buttons, select one of the 12 colour change programs PG01 - PG12. The colours can spread over the entire width
of the LED bar, or be displayed in the 3 segments of the LED bar. The colour change occurs abruptly, and the colours are blended into each
other. The speed of the programs is separately adjustable and a
stroboscope effect can also be activated.
Setting the program running speed: Once you have selected one of the 12 programs, press ENTER to confirm. The display changes to "SPxx"
(Speed). Now you can adjust the speed as desired by using the UP and DOWN buttons (SP01 = slowest, SP99 = fastest speed).
Setting the strobe effect: Now, press ENTER again (the display changes to "FSxx") and using the UP and DOWN buttons, select the strobe
speed (FS00 = strobe effect deactivated, FS01 = slowest frequency, FS99 = fastest frequency). Once the desired stroboscope effect has
been set, press ENTER to confirm the input.
With the PG05 program, the colour can be adjusted in addition to the running speed and strobe effect. After setting the strobe effect as
desired, and confirming the input with ENTER, the display shows "C1-x". Now use the UP and DOWN buttons to select the desired colour
(C1-1 to C1-7) and press ENTER to confirm.
Program PG06 provides the ability to set both changing colours individually. After setting the strobe effect as desired, and confirming the
input with ENTER, the display shows "C1-x". Now use the UP and DOWN buttons to select the desired program colour (C1-1 to C1-7) and
press ENTER to confirm. In the same way, you can now select the program colour 2 (C2-1 to C2-7). Confirm the input with ENTER.
6
= Blackout C--4
= Red C--5
= Green C--6
= Blue C--7
= Cyan
= Yellow
= Magenta
= White