Operation - Cameo AZOR S2 Manual De Usuario

OPERATION

NOTES
When the spotlight is started, "Update Wait" briefly appears on the display, then "Welcome to
Cameo", the model name and the software version. The motors are then reset (Motor Reset
Please Wait). After this process, the spotlight is operational and the previously activated operating
mode is launched.
MAIN DISPLAY IN DMX MODE
The main display in DMX mode shows the currently set DMX start address (see illustration). If the
spotlight has no DMX signal, the characters on the display flash.
DMX Address
001
SETTING DMX START ADDRESS (DMX Address)
Starting from the main display, press MENU to enter the main menu. Now use
menu item DMX Address and confirm with ENTER. Now use the
desired DMX start address and press ENTER to confirm (highest value dependent upon activated
DMX mode).
-------- Menu --------
DMX Address
DMX Mode
Stand Alone
Slave
Settings
System Info
CONFIGURING DMX MODE (DMX Mode)
Starting from the main display, press MENU to enter the main menu. Now use
the menu item DMX Mode and confirm with ENTER. Again use
mode and confirm with ENTER. Tables with the channel assignment of the different DMX modes
can be found in these instructions under DMX CONTROL.
-------- Menu --------
DMX Address
DMX Mode
Stand Alone
Slave
Settings
System Info
14
--- DMX Address ---
DMX Address
001
DMX Mode
Stand Alone
Slave
----- DMX Mode -----
21CH Basic
24CH Standard
28CH Extended
or to select the
or buttons to configure the
or to select
or to select the desired DMX