Pioneer MVH-X690BS Manual De Instrucciones página 5

Keep new and used batteries away from children.
If the battery compartment does not close securely, stop using the product and keep it away from
children.
If you think batteries might have been swallowed or placed inside any part of the body, seek
immediate medical attention.
• Do not expose the battery or remote control to excessive heat such as direct sunlight or fire.
CAUTION
• There is a potential danger of explosion if the battery is incorrectly replaced. When replacing the
battery, replace it with the same type.
• Do not handle or store the battery with metallic tools or objects.
• If the battery leaks, remove the battery and wipe the remote control completely clean. Then install a
new battery.
• When disposing of used batteries, please comply with governmental regulations or environmental
public institutions' rules that apply in your country/area.
• "Perchlorate Material - special handling may apply.
See www.dtsc.ca.gov/hazardouswaste/perchlorate. (Applicable to California, U.S.A.)"
Important
• Do not store the remote control in high temperatures or direct sunlight.
• Do not let the remote control fall onto the floor, where it may become jammed under the brake or
accelerator pedal.
Setup menu
When you turn the ignition switch to ON after installation, the setup menu appears in
the display.
WARNING
Do not use the unit in standard mode when a speaker system for network mode is connected to the
unit. Do not use the unit in network mode when a speaker system for standard mode is connected to
the unit. This may cause damage to the speakers.
1
Turn the M.C. dial to select the options, then press to confirm.
To proceed to the next menu option, you need to confirm your selection.
Menu Item Description
CLOCK SET Set the clock.
1 Turn the M.C. dial to adjust the hour, then press to confirm.
The indicator moves to the minute setting automatically.
2 Turn the M.C. dial to adjust the minute, then press to confirm.
Menu Item Description
SPEAKER MODE Switch between two operation modes: the 2-way network mode
(NETWORK) and the standard mode (STANDARD) according to
[STANDARD],
the connections you have established. For details on operation
[NETWORK]
modes, see page 15.
After selecting the appropriate mode, turn the M.C. dial to
select [YES], then press to confirm.
• You cannot complete the setup menu without setting the
[SPEAKER MODE].
• Once the speaker mode is set, this setting cannot be changed
unless the default settings of this product are restored. Restore
the default settings to change the speaker mode setting (refer
to SYSTEM RESET on page 6).
2
[QUIT :YES] appears when all the settings have been made.
To return to the first item of the setup menu, turn the M.C. dial to select [QUIT :NO],
then press to confirm.
3
Press the M.C. dial to confirm the settings.
NOTE
[CLOCK SET] can be made at any time. See page 19 for more details.
Canceling the demonstration display (DEMO OFF)
1
Press the M.C. dial to display the main menu.
2
Turn the M.C. dial to select [SYSTEM], then press to confirm.
3
Turn the M.C. dial to select [DEMO OFF], then press to confirm.
4
Turn the M.C. dial to select [YES], then press to confirm.
INITIAL settings
1
Press and hold SRC/OFF until the unit turns off.
2
Press the M.C. dial to display the main menu.
3
Turn the M.C. dial to select [INITIAL], then press to confirm.
4
Turn the M.C. dial to select an option, then press to confirm.
NOTE
The options vary depending on the unit.
5
En