Switch On/Off Sound; Activation After Selecting The Programme; Quick Start; De-Activation - CASO DESIGN MG20 CERAMIC menu Manual Del Usuario

15.5 Switch on/off sound

Press the button Power/sound for three seconds in order to switch on or off
the sound (beep tone).
You can hear messages of the programme ending and warning signals even if
the sound has been switched off.

15.6 Activation after selecting the programme

After selecting the program, press the button Start/Quickstart, to start the
preset cooking programme.

15.7 Quick start

Utilise this function to programme the oven for comfortable cooking at 100%
microwave performance. Press the Start/Quickstart button in quick sequence
to set the cooking time. The oven starts automatically after 2 seconds.
Once the end of the cooking time is reached, three signal tones will be emitted
and END will appear in the display.

15.8 De-activation:

In order to interrupt an ongoing cooking programme, you can proceed as follows:
Press the Stop button once. The cooking programme that is in use will be
stopped. Open the door of the device. The cooking programme that is in use
will be stopped.
►
Start/Quickstart after closing the door.
To terminate the interrupted program, press the button Stop a second time.
Before beginning a different cooking process you must delete the display and
reset the system by pressing the button Stop.

15.9 Setting the clock

To set the clock on the device, proceed as follows:

Press the button Time/Weight.
Press the button once again to switch the oven from the 24 hour system to the
12 hour system.

Turn the control dial Time/Menu until the correct hour is displayed.
Press the Time/Weight button to save the set hour.
Please note
To continue the interrupted cooking program, press the button
Please note
Activating setup mode
Setting the hours
58