Troubleshooting; Safety Notices; Causes And Rectification Of Faults - CASO DESIGN MG20 CERAMIC menu Manual Del Usuario

 Wipe off any steam, which has settled on the oven door, with a soft cloth. This may be the
case if the device is used in an extremely damp environment and is normal.
 Smells can be removed from the oven by mixing a cup of water with the juice and the skin
of a lemon, pouring this into a deep microwave-proof bowl and allowing it to cook in
Microwave mode for five minutes. Then, dry off the oven thoroughly with a soft cloth.
 After cleaning the interior space, leave the oven door open until the interior of the device
is completely dry.
 Front of device and operating panel
 Clean the front of the device and the operating panel with a soft, slightly damp cloth.
 Please bear in mind that the operating panel does not get wet. Use a soft, damp cloth for
cleaning.
► Leave the oven door open to prevent the device from being re-started accidentally.
 Exterior housing
 Clean the exterior surfaces of the device with a damp cloth.
 Metal rack and base plate
The metal rack occasionally needs to be cleaned. Wash the metal rack in a warm soap
solution. Wipe the bottom of the oven with a mild cleaning agent. If the floor of the oven is
excessively dirty, you can use a mild cleaning agent.

17 Troubleshooting

This chapter provides you with important notices with regard to operating the device.
Observe the following notices to avoid dangers and damages:

17.1 Safety notices

Attention
► Only qualified electricians, who have been trained by the manufacturer, may carry out any
repairs on electrical equipment.
► Improperly performed repairs can cause considerable dangers for the user and damages
to the device.

17.2 Causes and rectification of faults

The following table assists in localizing and rectifying minor faults.
Error
The selected program
will not start.
Please note
Possible cause
Device door is not closed
Power plug is not plugged in
Action
Close device door
Plug in mains plug!
64