Dial-A-Depth™ Fastener Control Adjustment - Bostitch N59FN Manual De Operación Y De Mantenimiento

Always disconnect air supply: 1. Before making adjustments; 2. When
servicing the tool; 3. When clearing a jam; 4. When tool is not in use;
5. When moving to a different work area, as accidental actuation may occur,
possibly causing injury.
"DIAL-A-DEPTH
The DIAL-A-DEPTH
drive depth; from flush with the work surface to shallow or deep countersink. First, set the air pres-
sure for consistent drive in the specific work as described on page 8, then use the DIAL-A-DEPTH
Fastener Control adjustment to give the desired depth of drive.
TO ADJUST DIAL-A DEPTH
1.With air pressure set (refer to Setting the
Correct Pressure on Page 8), drive a few
fasteners into a representative material
sample to determine if adjustment is
necessary.
2. If adjustment is required, disconnnect air
supply.
3.Open trip cover and turn adjusting nut as
shown to set the desired fastener
countersink depth.
4.Close cover. Before reconnecting air
supply, check that trip mechanism parts
operate freely with no binding or sticking.
Models N50FN, N59FN and N60FN, contain a Quick Release Door feature. The door is designed to
"pop" open if a jam occurs providing easy access for removing a jammed fastener.
ALWAYS DISCONNECT AIR SUPPLY BEFORE CLEARING A JAMMED FASTENER.
If the door does not "pop" open when a jam occurs, it can easily be opened with a screwdriver, as
shown in illustration #1. Use a firm twist on the screwdriver to open the door, see illustration #2.
The door will not open completely if the driver is still down. To open the door completely the driver must
be pushed back into the tool.
The "Quick Release Door" makes cleaning the nose and front portion of the magazine a rapid and easy
operation with a minimum of effort.
To close the door simply press the door firmly against the edge of the work table or suitable stationary
object until the two latch pins snap into a locked position.
CAUTION: Do not use your hands to close the door as injury may occur if skin is pinched
between the door and nose when the latch pins engage.
1.
" FASTENER CONTROL ADJUSTMENT
™
Fastener Control adjustment feature provides close control of the fastener
™
TM
FASTENER CONTROL ADJUSTMENT:
Away from magazine for less countersink or flush.
Toward magazine to increase countersink.
QUICK RELEASE DOOR
2.
-11-
™
TRIP COVER