Publicidad
Idiomas disponibles
Idiomas disponibles
N59FN/N50FN/N60FN TOOL SPECIFICATIONS
All screws and nuts are metric.
MODEL
LENGTH
N50FN
13.25" (336.55mm) 10.00" (254mm)
N59FN/N60FN 14.12" (358.65mm) 10.88" (276.35mm) 3.00" (76.2mm) 4.37lbs (1.98kg)
FASTENER SPECIFICATIONS:
TOOL MODEL NAIL SERIES
N50FN
FN1600
N59FN/N60FN FN1500
TOOL AIR FITTING:
This tool uses a 1/4" N.P.T. male plug. The inside diameter should be .200" (5mm) or
larger. The fitting must be capable of discharging tool air pressure when disconnected
from the air supply.
OPERATING PRESSURE:
70 to 100 p.s.i.g. (4.9 to 7.0 kg/cm
best fastener performance. DO NOT EXCEED THIS RECOMMENDED OPERATING
PRESSURE.
AIR CONSUMPTION:
Model N50FN requires 1.6 cubic feet per minute and Model N59FN/N60FN requires
1.7 cubic feet per minute of free air to operate at the rate of 60 fasteners per minute,
at 80 p.s.i.g. To calculate the actual rate at which the tool will be run to determine the
amount of air required, for example; if your usage averages 30 fasteners per minute,
you need 50% of the 1.6 c.f.m. or 1.7 c.f.m. which is required for running at 60 fasteners
per minute.
OPERATION
BOSTITCH OFFERS THREE TYPES OF OPERATION FOR THIS SERIES TOOL.
CONTACT TRIP
The common operating procedure on "Contact Trip" tools is for the operator to contact the
work to actuate the trip mechanism while keeping the trigger pulled, thus driving a
fastener each time the work is contacted. This will allow rapid fastener placement on
many jobs, such as sheathing, decking and pallet assembly. All pneumatic tools are
subject to recoil when driving fasteners. The tool may bounce, releasing the trip, and if
unintentionally allowed to recontact the work surface with the trigger still actuated
(finger still holding trigger pulled) an unwanted second fastener will be driven.
SEQUENTIAL TRIP
The Sequential Trip requires the operator to hold the tool against the work before pulling
the trigger. This makes accurate fastener placement easier, for instance on framing, toe
nailing and crating applications. The Sequential Trip allows exact fastener location without
the possibility of driving a second fastener on recoil, as described under "Contact Trip".
The Sequential Trip Tool has a positive safety advantage because it will not accidentally
drive a fastener if the tool is contacted against the work – or anything else – while the
operator is holding the trigger pulled.
TRIGGER OPERATED
The Trigger Operated model is cycled by actuation of the trigger only. This model does
not have a Contact Arm and is intended for use only where a Contact Arm CANNOT be
used to satisfy the requirements of the application.
The Trigger Operated tool will cycle each time the trigger is actuated.
MODEL IDENTIFICATION:
Refer to Operation Instructions on page 4 before proceeding to use this tool.
CONTACT TRIP
Identified by:
BLACK TRIGGER
HEIGHT
GAUGE
WIRE SIZE
16
.060 (1.52mm)
15
.072 (1.82mm)
2
). Select the operating pressure within this range for
SEQUENTIAL TRIP
Identified by:
GRAY TRIGGER
-4-
WIDTH
WEIGHT
3.00" (76.2mm) 4.12lbs (1.87kg)
FASTENER RANGE
1"-2" (25mm-50mm)
1-1/4" - 2-1/2" (32mm-63mm)
TRIGGER OPERATED
Identified by:
BLACK TRIGGER
Publicidad
Capítulos
