Tool Specifications - Bostitch MCN150 Manual De Operación Y De Mantenimiento

MAINTAINING THE TOOL
When working on air tools note the warnings in this manual and use extra care when
evaluating problem tools.
MCN150 / MCN250 / MCN250S TOOL SPECIFICATIONS
All screws and nuts are metric.
MODEL
MCN150
MCN250
MCN250S
FASTENER SPECIFICATIONS:
MCN150: Uses a 35° paper collated full round head metal connector nails, in lengths of 1-1/2" (38mm) and
shank diameters of .131", .148".
MCN250 & MCN250S: Uses a 35° paper collated full round head metal connector nails, in lengths of 1-1/2"
and 2-1/2" (38 - 64mm) and shank diameters of .131", .148", .162".
TOOL AIR FITTING:
This tool uses a 1/4" N.P.T. male plug. The inside diameter should be .200" (5mm) or larger. The fitting must
be capable of discharging tool air pressure when disconnected from the air supply.
OPERATING PRESSURE:
70 to 120 p.s.i.g. (4.9 to 8.4 kg/cm2 ). Select the operating pressure within this range for best fastener
performance. DO NOT EXCEED THIS RECOMMENDED OPERATING PRESSURE.
AIR CONSUMPTION:
The MCN150 requires 6.7 cubic feet per minute (190 liters per minute) of free air to operate at the rate of 100
nails per minute, at 80 p.s.i. (5.6 kg/cm
amount of air required. For instance, if your fastener usage averages 50 nails per minute, you need 50% of the
6.7 c.f.m. (190 liters per minute) which is required to operate the tool at 100 nails per minute.
The MCN250 & MCN250S requires 7.7 cubic feet per minute (218 liters per minute) of free air to operate at the
rate of 100 nails per minute, at 80 p.s.i. (5.6 kg/cm
deteremine the amount of air required. For instance, if you fastener usuage averages 50 nails per minute, you
need 50% of the 7.7 c.f.m. (218 liters per minute) which is required to operate the tool at 100 nails per minute.
TOOL
LENGTH
ACTUATION
Sequential Trip 11-3/4" (296 mm)
Sequential Trip 16-1/8" (410 mm)
Sequential Trip 11-3/4" (296 mm)
2 ). Take the actual rate at which the tool will be run to determine the
HEIGHT
10-1/2" (267 mm)
14" (356 mm)
14" (356 mm)
2 ). Take the actual rate at which the tool will be run to
4
WIDTH WEIGHT
3-1/2" (85.7 mm) 4.3 lb. (1.95 kg.)
3-1/2" (85.7 mm) 6.0 lb. (2.72 kg.)
3-1/2" (85.7 mm) 5.5 lb. (2.59 kg.)