Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
A HARDWARE TOUR
REAR VIEW
8 Audio output
This is a connector for output of analog audio.
As a Molex 70553 type connecter is used, select a matching connection cable.
9 Function switch
Use the accessory short-circuit sockets to set the SCSI ID number and the drive
function.
÷ ON :
put a short-circuit socket
÷ OFF :
open
#1 ~ 3 :
SCSI ID
Setting switch
0 (LSB) (#1) OFF ON OFF ON OFF ON OFF ON
1
(#2) OFF OFF ON ON OFF OFF ON ON
2 (MSB) (#3) OFF OFF OFF OFF ON ON ON ON
#4 :
Reserved
#5 :
SCSI Terminator
ON = SCSI termination enable
OFF = SCSI termination disable
#6 :
Default sector size
ON = 512 bytes
OFF = 2048 bytes
#7 :
Disable the eject switch
ON = Disables the eject switch
OFF = Enables the eject switch
1
2
#8*
*
:
RPC (Region Play Control) Set
ON = Stay in RPC Phase I mode
OFF = Start RPC Phase II mode (Never return to Phase I mode after
1
*
Pin 2 and Pin 8 (RPC SET) are ON at the time of shipping from the plant.
2
*
For a DVD Video playback system (computer) for Phase I, please use with Phase I. When the DVD
Video playback system (computer) and the drive have different region codes, DVD Video playback is
not possible.
Set the jumper switch to OFF only when use of a drive corresponding to Phase II has been speci-
fied clearly for the DVD Video playback system (computer). The drive will be initialized automatically
and will operate in Phase II mode.
0 SCSI interface
This is a 50-pin I/O connector according to the SCSI-2 specifications. Use a flat
ribbon SCSI connector to connect to the SCSI host adapter.
- DC Input
This is the power supply input for DC +5 V and +12 V.
8
<DRC1095>
En
49
1
4
1
8
50
8
9
* The factory setting is ID No. 2.
SCSI-ID
1
0
1
2*
3
Phase II mode is used)
0
4
5
6
7
2048/512
DISABLE EJECT
RPC SET
Switch #
8
7
1
DC INPUT
2
+5 G G +12
-
Fig. 2
TERMINATION (SHORT – ON)
RESERVED
SCSI ID
2
1
0
6
5
4
3
2
1
Publicidad
Tabla de contenido
