marklin Köf II Serie Manual De Instrucciones página 5

Function
• Possible operating systems:
6646/6647 Märklin Transformer, Märklin Delta,
Märklin Digital, Märklin Systems.
• Recognition of the mode of operation: automatic.
• Addresses that can be set: 01 – 80
Address set at the factory: 23
• Adjustable acceleration/braking delay (simul-
taneous). Adjustable maximum speed.
• Setting the locomotive parameters (address, acce-
leration/braking delay, maximum speed): with the
Control Unit, Mobile Station, Central Station.
• Headlights, changing over with the direction of
travel.
It is not necessary to open the locomotive for mainte-
nance work. Disassembling the locomotive automati-
cally invalidates the manufacturer warranty.
In principle the pulling power for this model is limited.
The maximum grade it can negotiate with 2 to 3
twoaxle freight cars is about 3 %.
The maintenance work necessary with normal operation
of this locomotive is described below. Please see your
authorized Märklin dealer for repairs or spare parts.
No warranty or damage claims shall be accepted in those cases
where parts neither manufactured nor approved by Märklin have
been installed in Märklin products or where Märklin products have
been converted in such a way that the non-Märklin parts or the
conversion were causal to the defects and/or damage arising. The
burden of presenting evidence and the burden of proof thereof,
that the installation of non-Märklin parts or the conversion in or
of Märklin products was not causal to the defects and/or damage
arising, is borne by the person and/or company responsible for the
installation and/or conversion, or by the customer.
Safety Warnings
• This locomotive is to be used only with an operating
system designed for it (Märklin 6646/6647 AC
transformer, Märklin Delta, Märklin Digital or Märklin
Systems). Under no circumstances should transfor-
mers rated for an input of 220 volts be connected to
the American 110 volt household current system.
• This locomotive must never be supplied with power
from more than one transformer.
• The feeder track must be equipped to prevent
interference with radio and television reception,
when the locomotive is to be run in conventional
operation. The 74046 interference suppression set
is to be used for this purpose. The interference
suppression set is not suitable for digital operation.
• Pay close attention to the safety warnings in the
instructions for your operating system.
5