Pairing And Connection Using Nfc; Radio Wave Caution - Pioneer X-CM66D Manual De Instrucciones

®
Bluetooth Audio playback

Pairing and connection using NFC

NFC stands for Near Field Communication. If a NFC-
equipped smartphone is placed close to the unit, Bluetooth
pairing and connection can easily be established. For
details, refer to the user manual for the NFC-equipped
device.
Note
• Supported OS: Android 4.1 and above
• This may not operate properly, depending on the
smartphone or tablet device.
• This unit automatically turns on if an NFC-equipped
smartphone is held over the NFC area when Network
Standby is set to ON.
• The N Mark is a trademark or registered trademark of
NFC Forum, Inc. in the United States and in other
countries.
• Android is a trademark of Google Inc.
1 Hold the device to be connected over the
NFC area on the front panel of the unit.
When an NFC-equipped smartphone is detected, the input
automatically switches to Bluetooth .
2 Pairing automatically begins.
When an NFC-equipped smartphone is detected, Pairing
displays on the front panel display.
• Do not move the NFC-equipped smartphone until a
response such as message display can be confirmed
on the device. Remove the device after a response is
confirmed on the device.
• If a connection does not start, change the position to
hold the NFC-equipped smartphone over this unit.
3 Once connection with the NFC-equipped
smartphone is completed, the device name is
displayed on the front panel display of this unit.
4 Start playback of the music from the NFC-
equipped smartphone.
Note
• Only one device can be connected at a time.
• NFC can also be used to quickly cancel a Bluetooth
connection. If you perform Step 1 using a NFC-
equipped smartphone that is already connected via
Bluetooth , the connected will be cancelled.
• If another NFC-equipped smartphone is held over the
NFC area, this unit connects to the device via
Bluetooth. The connection with the previously
connected device is terminated.

Radio wave caution

This unit uses a 2.4 GHz radio wave frequency, which is a
band used by other wireless systems (see list below). To
prevent noise or interrupted communication, do not use this
unit nearby such devices, or make sure these devices are
switched off during use.
• Cordless phones
• Cordless facsimiles
• Microwave ovens
• Wireless LAN devices (IEEE802.11b/g)
• Wireless AV equipment
• Wireless controllers for game systems
• Microwave-based health aids
• Some baby monitors
Other, less common, equipment that may operate on the
same frequency:
• Anti-theft systems
• Amateur radio stations (HAM)
• Warehouse logistic management systems
• Discrimination systems for train or emergency vehicles
Note
• In the event noise appears in your television image,
there is the possibility that a Bluetooth wireless
technology enabled device or this unit (including
products supported by this unit) are causing signal
interference with the antenna input connector of your
television, video, satellite tuner, etc. In this event,
increase the distance between the antenna input
connector and the Bluetooth wireless technology
enabled device or this unit (including products
supported by this unit).
• If there is something obstructing the path between this
unit (including devices supported by this unit) and the
device equipped with Bluetooth wireless technology
(such as a metal door, concrete wall, or insulation
containing tinfoil), you may need to change the location
of your system to prevent signal noise and interruptions.
10
29
En