Using A Cellular Phone To Initiate A Connection; Disconnecting A Cellular Phone; Registering Connected Cellular Phone; Deleting A Registered Phone - Pioneer DEH-P65BT Manual De Operación

Operating this unit
Using a cellular phone to initiate a
connection
Putting the unit in CONNECTION OPEN mode
allows you to establish a Bluetooth wireless
connection from your phone. You may need to
refer to the operation manual that came with
your phone if you are unsure how to initiate a
connection from your phone.
1 Use MULTI-CONTROL to select
CONNECTION OPEN in the function menu.
2 Press MULTI-CONTROL to open the con-
nection.
CONNECT WAITING is displayed and the unit
is now on standby for connection from cellular
phone.
3 Use cellular phone to connect to this
unit.
# Operation varies depending on the type of
your cellular phone. Refer to the instruction man-
ual that came with your cellular phone for de-
tailed instructions.
# You may need to enter the link code on your
cellular phone to complete the connection.
# The link code is set to 0000 as default. You
can change this code in the initial setting. Refer
to Entering PIN code for Bluetooth wireless con-
nection on page 41.

Disconnecting a cellular phone

When you are done using your phone with this
unit, you can close the Bluetooth wireless con-
nection.
1 Use MULTI-CONTROL to select
DISCONNECT PHONE in the function menu.
Device name of the connected phone appears
in the display.
2 Press MULTI-CONTROL to disconnect a
cellular phone from this unit.
After the disconnection is completed,
DISCONNECTED is displayed.
All manuals and user guides at all-guides.com
Registering connected cellular
phone
You can register a phone that is temporarily
connected to this unit in order to take full ad-
vantage of the features available with Blue-
tooth wireless technology. A total of three
phones can be registered.
1 Use MULTI-CONTROL to select
SET PHONE in the function menu.
2 Push MULTI-CONTROL up or down to
select a registration assignment.
P1 (user phone 1)—P2 (user phone 2)—P3
(user phone 3)
# As you select each assignment, you can see
whether or not a phone is already registered
there. If the assignment is empty, NO DATA is
displayed. If the assignment is already taken, the
device name appears. To replace an assignment
with a new phone, first delete the current assign-
ment. For more detailed instructions, see Deleting
a registered phone on this page.
# If you need to know the BD (Bluetooth Device)
address of the phone, push MULTI-CONTROL left
here.
3 Press MULTI-CONTROL to register the
currently connected phone.
When the registration is completed,
REG COMPLETED is displayed.
# If the registration failed, REG ERROR is dis-
played. In this case, return to step 1 and try
again.

Deleting a registered phone

If you no longer need to use a registered
phone with this unit, you can delete it from the
registration assignment for another phone.
! If a registered phone is deleted from this
unit, the Phone Book and other settings of
that phone are cleared simultaneously.
1 Use MULTI-CONTROL to select
DELETE PHONE in the function menu.
Section
02
25
En