Troubleshooting - Urrea 23622 Manual De Usuario

GENERAL MAINTENANCE
Using Clean Grease will give you years of trou-
ble free use. Make sure that Grease use is not
contaminated.

TROUBLESHOOTING

Pump does not Dispense Grease
1. 1.Air Pockets / Trapped Air in Grease: Shake
the tray slightly to compress the air inside.
Additionally open the air release valve on the
pump head and operate the handle until grea-
se starts to come out of the valve.
2. Follower plate got stuck: Open the drum
cover re-insert-monitoring plate and replace
the steel cover on the tray. When you do this
step, you must insert the steel bomb in the cen-
ter hole of the plate. Place the drum lid and
close the 3 clamps.
3.Very Thick Grease, mainly in cold weather:
Warm the Grease Bucket a little
4.Contaminants causing blockage: Dis-assem-
ble the pump to remove the blockage Grease
leaks from top of the pump head.
Grease leaks from top of the pump head
Worn Plunger Rod Seal Replace the seal: This
is a commonly wearing part & available as a
spare part.
8