Operating Controls; Factory Settings; Condensation Protection (Only On 3-Door Appliances) - Bosch B36IT900NP Instrucciones De Uso

en-us Getting to know your appliance

Operating controls

(
0
8
@
menu button
(
Opens mode selection.
button
0
Ò
Opens the Settings menu.
~ "Settings" on page 10
Refrigerator compartment temperature
8
display
Indicates the set temperature in °C/°F.
Freezer compartment temperature display
@
Indicates the set temperature in °C/°F.
Mode selection
To open mode selection, press menu button.
To switch on a mode, tap on it. When a mode is
switched on, it, is highlighted in red in the mode
selection menu.
An Info window with additional information on the
mode selected appears.
Eco mode
Switch the appliance to energy-
saving mode.
~ "Eco mode" on page 14
Vacation mode
If absent for a long time, you will
save energy here.
~ "Vacation mode" on page 14
Sabbath mode
All non-essential functions are
switched off so you can also use the
appliance on the Sabbath.
~ "Sabbath mode" on page 14
10
39
F
°
0
F
°
Settings
Tap to open the settings.
Ò
Language
Õ
Change the display language.
Home Connect
Ö
Connect your refrigerator to your mobile
device.
~ "Home Connect" on page 15
Tones
È
Set the volume of the button tone and the
signal tone.
Display brightness
Ö
Adjust the brightness of the display.
Temperature unit
Í
Select the temperature unit °C/°F.
Ice cube production
Î
Start or stop ice cube production.Stopping
ice cube production is a good idea before
cleaning the freezer compartment, or if you
are going to be absent for a long time.
Water filter counter
Ï
If you have changed the water filter, you
must reset the water filter counter. If you
have replaced it with a bypass cartridge, you
can switch the water filter counter off.
~ "Water filter" on page 12

Factory settings

Ð
Set the settings of the appliance back to its
factory settings on delivery.
Self-test
Ñ
Start fault analysis on your appliance.
Condensation protection (only on 3-door
æ
appliances)
On 3-door appliances, a heater is built into
the door pillar to prevent condensation. This
menu is used to switch condensation
protection on or off.
~ "Switching Prevent condensation on or
off" on page 14
Demo mode
m
Note: Do not store any food items while in
demo mode, as the appliance then remains
at room temperature.
The cooling function of the appliance is
switched off.You can use all other functions.
After switching on the appliance, this menu
item is displayed for 3 minutes. To switch
demo mode on or off later, switch the
appliance off and back on. The mode is
displayed again for 3 minutes.