Specifications - Sony VPL-CX75 Manual De Instrucciones

Specifications

Optical characteristics
Projection system
3 LCD panels, 1 lens, projection
system
LCD panel 0.79-inch XGA panel, about
2,360,000 pixels (786,432
pixels × 3)
Lens 1.2 times zoom lens (powered)
f 23.5 to 28.2 mm/F1.6 to 1.78
Lamp 165 W UHP
Projection picture size
40 to 300 inches (measured
diagonally)
Light output ANSI lumen
CX75)
ANSI lumen
CX70)
(When the Lamp Mode is set to
"High")
Throwing distance (When placing on the floor)
When the XGA signal is input
40-inch: 1.2 to 1.4 m
(3.9 to 4.6 feet)
80-inch: 2.4 to 2.7 m
(7.9 to 8.9 feet)
100-inch: 3.0 to 3.4 m
(9.8 to 11.2 feet)
150-inch: 4.5 to 5.2 m
(14.8 to 17.1 feet)
200-inch: 6.0 to 6.9 m
(19.7 to 22.6 feet)
250-inch: 7.5 to 8.7 m
(24.6 to 28.5 feet)
300-inch: 9.0 to 10.4 m
(29.5 to 34.1 feet)
There may be a slight difference between the
actual value and the design value shown above.
1) ANSI lumen is a measuring method of
American National Standard IT 7.228.
Electrical characteristics
Color system NTSC
3.58
NTSC
PAL60 system, switched
automatically/manually
(NTSC
when playing back a video
recorded on NTSC on a
NTSC
Resolution 750 horizontal TV lines (Video
input)
50
GB
Specifications
1)
2500 lm (VPL-
1)
2000 lm (VPL-
/PAL/SECAM/
/PAL-M/PAL-N/
4.43
is the color system used
4.43
system VCR.)
4.43
1,024 × 768 dots (RGB input)
Acceptable computer signals
fH: 19 to 92 kHz
fV: 48 to 92 Hz
(Maximum input signal resolution:
SXGA+ 1400 × 1050
fV: 60 Hz
1) Set the resolution and the frequency of the
signal of the connected computer within the
range of acceptable preset signals of the
projector.
Applicable video signals
15 k RGB 50/60 Hz, Progressive
component 50/60 Hz, DTV
(480/60I, 575/50I, 480/60P,
575/50P, 540/60P, 720/60P,
720/50P, 1080/60I, 1080/50I),
Composite video, Y/C video
Monaural speaker system, 40 × 20
Speaker
mm (1
1 W
Input/Output
Video input VIDEO: phono type
Composite video: 1 Vp-p ±2 dB
sync negative (75 ohms
terminated)
S VIDEO: Y/C mini DIN 4-pin
type
Y (luminance): 1 Vp-p ±2 dB
sync negative (75 ohms
terminated)
C (chrominance): burst
0.286 Vp-p ±2 dB (NTSC)
(75 ohms terminated),
burst 0.3 Vp-p ±2 dB (PAL)
(75 ohms terminated)
INPUT A HD D-sub15-pin (female)
Analog RGB/component:
R/R-Y: 0.7 Vp-p ±2 dB
(75 ohms terminated)
G: 0.7 Vp-p ±2 dB
(75 ohms terminated)
G with sync/Y: 1 Vp-p ±2 dB
sync negative
(75 ohms terminated)
B/B-Y: 0.7 Vp-p ±2 dB
(75 ohms terminated)
SYNC/HD:
Composite sync input: 1-5 Vp-p
high impedance, positive/
negative
Horizontal sync input: 1-5 Vp-p
high impedance, positive/
negative
VD:
1)
×
5 13
/ / inches), max.
8 16