Hilti TE 60-A36 Manual De Instruccion página 23

Trouble or fault
Drill bit does not
rotate.
The insert tool can-
not be released from
the chuck.
Product does not
start.
The service indicator
lights.
The service indicator
blinks.
The ON/OFF indica-
tor flashes.
9 Disposal
Most of the materials from which Hilti tools and appliances are manu-
factured can be recycled. The materials must be correctly separated before
they can be recycled. In many countries, your old tools, machines or appli-
ances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti
representative for further information.
▶ Do not dispose of power tools, electronic equipment or batteries as
household waste!
*2201899*
Possible cause
The function selector
switch is not engaged or
is in the "Chiseling" po-
sition or the "Chisel
positioning" position
The chuck is not pulled
back fully.
The side handle is not
fitted correctly.
The electronic restart
interlock is activated
after an interruption in
the electric supply.
Service limit time
reached.
The product is faulty.
Product momentarily
overloaded.
Protection against over-
heating.
2201899
Action to be taken
▶ With the motor at
a standstill, set the
function selector
switch to the "Hammer
drilling" position.
.
▶ Pull the chuck back
as far as it will go and
remove the accessory
tool.
▶ Disengage the side
handle and refit it
correctly so that the
clamping band and
side handle engage in
the recess.
▶ Switch the product off
and then on again.
▶ Have the product
repaired by Hilti
Service.
▶ Have the product
repaired by Hilti
Service.
▶ Release the control
switch and then press
it again.
▶ Allow the product to
cool down and clean
the air vents.
English 17