Control Panel; Operating Modes; Cool Mode; Dry Mode - Danby DPA100HB1BDB-6 Manual Del Propietário

OPERATING INSTRUCTIONS

CONTROL PANEL

1. Swing and wireless connect button:
• Press to start the auto swing feature. When auto
swing is activated, press again to stop the louver
at the desired angle.
• Press and hold for three seconds to start using
the wireless connect feature.
2. Timer button: Press to start the automatic timer.
Light will indicate whether a timer is set.
3. Mode button: Press to select the desired mode.
Light will indicate current mode.
4. Temperature control buttons:
• Used to set the temperature and timer.
• Press and hold both temperature control buttons
for three seconds to change the temperature
display from °C to °F.
5. LED display:
• Shows the set temperature in °C or °F.
• Shows the timer settings.
• While on dry or fan mode, shows the room
temperature.
6. Fan button:
• Press to select fan speed. Light will indicate
current speed.
• Press and hold for 3 seconds to turn the
continuous fan on or off.
7. Sleep button: Press to start the sleep feature.
8. Power button: Press to turn the appliance on or
off.
2
1
3sec
3

OPERATING MODES

Cool Mode

Choose cool mode to set the cooling function.
• Use the temperature control buttons to choose
the desired temperature.
• Use the fan button to choose the desired fan
speed.
• The temperature can be set within a range of 17
- 30°C (62 - 86°F).
• The exhaust hose should be installed during cool
mode to ensure the best results.

Dry Mode

Choose dry mode to remove excess moisture from
the air. Water will condense inside the appliance
and drain out the back.
• The humidity level and fan speed will be
automatically set and cannot be modifi ed in dry
mode.
• The exhaust hose does not need to be installed
during dry mode.
• It may be necessary to install the continuous
drain hose during dry mode to remove excess
water.
5
6
4
10
7
3sec
8