Care And Maintenance - LANDMANN 42170 Manual Del Usuario

Please use the following guidelines to keep your grill
clean and looking new. Before any cleaning, make
is cool to the touch.
Cleaning the Outside of the Grill
For the stainless steel surfaces, wash the outside of
the surface with a soft cloth and a soap and water
solution, and rinse with water.
of the stainless steel grain.
the stainless steel grain.
DO NOT clean stainless steel with anything
containing acid, mineral spirits or xylene.
DO NOT use a wire brush or any abrasive cleaner
on the stainless steel surface as this will cause
scratches in the stainless steel finish.
Cleaning the Inside of the Grill
For safety and efficiency, it is important to remove any
debris or excess grease that may accumulate inside
the grill.
prevent grease build up.
and rinse with water.
soapy water and rinse with water.
stainless steel rod grates. After cooking, turn
the burners to HIGH and run for approximately
15 minutes with the lid closed. Then turn off the
burners, carefully open the lid and use a wire brush
to clean the excess food residue off the grates.
with wire brush and wash with a mild soapy water.
Rinse with water.
off the inner box with a paper towel to remove
excess grease. Then wash the inside of box with
warm, soapy water and rinse with water. For easier
cleanups, you can line the interior of the box with
aluminum foil.
off the top surface with a paper towel to remove
excess grease. Then wash the top surface with
warm, soapy water and rinse with water.

Care and Maintenance

OFF position and grill
17
DO NOT line the grease tray with
aluminum foil.
Hose Inspection
The hose should be inspected periodically for any
signs of cracking, nicks, cuts or abrasions.
DO NOT use the grill.
shown in the replacement parts section.
Checking the Flame
The flame coming out of the burners should be a
blue/yellow combination and between one to two
inches tall (see below).
Yellow
2 in.(5 cm)
Light Blue
Blue
Good Flame
To Remove Burner
the LP gas supply valve has been closed, and the gas
hose is disconnected from the gas supply.
1. Open Lid and remove warming rack, cooking racks
and flame tents.
2. Using a 2 pt Phillips screwdriver, loosen the bolt
holding the burner in the back of the grill.
Note: This is a bolt/nut combination so make sure
to hold the nut while removing the bolt.
3. Slide the burner forward and out of the firebox.
4. Detach the ignition wire from the ignitor.
To Clean Burner
Tip: Use a pin or paper clip to unclog.
damage is found, replace the burner.
screen are clear from insect nests, dirt, or debris.
Yellow
Light Blue
Blue
Bad Flame
OFF position,