Troubleshooting Guide - Campbell Hausfeld AF010800 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

TROUBLESHOOTING GUIDE

SYMPTOM
Inflator does not turn on or
blows fuses
Inflator runs but tire/article does
not inflate
Inflator runs slowly
CORRECTIVE ACTION
1.
Push the power plug firmly into the receptacle and twist it
back and forth.
2.
Check receptacle and plug terminal for dirt. Use a non-
conductive probe--not fingers or anything metal—to check
and clean receptacle and/or terminal.
3.
Check vehicle power outlet fuse; should be a minimum of 10
amps.
4.
Check inflator fuse, located
in the plug adaptor. To
access fuse, unscrew the
tip of the plug adaptor,
remove old fuse and
inspect. Replace fuse, if
needed.
1.
Ensure universal adapter is properly seated on the valve stem
and tightened.
2a. Check tire/article for leaks. Check inflator hose for cracks and
leaks at fittings.
2b. Inspect tire/article to confirm there are no punctures or
sidewall tire damage.
3.
If the tire is completely flat, it is possible that the tire has
separated from the rim. If so, the tire inflator will not deliver
the volume of air needed to inflate tire.
1.
Inflator is overheated from too much use. Shut inflator off and
allow to cool for 20 minutes.
2.
Voltage powering the 12V outlet is too low. Check the
condition of (car) battery.
7

Publicidad

Tabla de contenido
loading

Tabla de contenido