Electrolux FI18/11E Manual De Instrucciones página 13

Problem
If the advice does not lead to
the desired result, contact
the nearest Authorised
Service Centre.
8.2 Replacing the lamp
The appliance is equipped
with a long-life LED interior
light.
It is strongly recommended
to use original spare parts
only.
Use LED bulbs (E14 base)
only. The maximum power is
shown on the lamp unit.
CAUTION!
Disconnect the plug from the
mains socket.
1. With your fingers, spread slightly
both sides of the transparent cover to
unhook them and detach the cover
pulling it in the direction of the
arrows.
2
Possible cause
The door has been
opened often.
There is no cold air circu‐
lation in the appliance.
1
1
Solution
Open the door only if neces‐
sary.
Make sure that there is cold
air circulation in the appli‐
ance.
2. Replace the lamp with the one that
has identical characteristics and is
specifically designed for household
appliances.
3. Reassemble the lamp cover.
4. Connect the plug to the mains
socket.
5. Open the door.
Make sure that the light switches on.
8.3 Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer
to assembly instructions.
3. If necessary, replace the defective
door gaskets. Contact the Authorised
Service Centre.
ENGLISH 13