B Ef O Re U Si Ng Your A Pplia Nc E - Oster FPSTJE320S Serie Manual De Instrucciones

B EF O RE U SI NG YOUR A PPLIA NC E

Follow the assembly instructions listed below before using your Oster
Extractor:
1. Before you start assembling your juice extractor, make sure it is unplugged and it
is placed on a dry and level surface.
2. Place filter basket on top of the motor base (Figure 1).
3. Place the stainless steel filter on top of the filter basket pushing down and turning
it until it fits into the grooves of the motor shaft (Figure 2).
4. Place juicer cover/lid on top of the filter basket (Figure 3).
Fig. 1
5. Raise the safety locking arm, then lower it to securely fit into the grooves in the
lid to ensure the lid is locked into the unit (Figure 4).
6. Place the pulp container into position by tilting it slightly (Figure 5).
IMPORTANT: Make sure pulp container edge is underneath basket.
7. Place the pitcher under the spout located on the right hand side of the juicer by
tilting it slightly. Other jars or glasses can be used as well (Figure 6).
Fig. 4
FPSTJE320S_FPSTJE320R_19SEM1 (LA).indd 4
Fig. 2
Fig. 5
En g lish- 4
®
Juice
Fig. 3
Fig. 6
10/16/19 09:54