Fein WSG7-115 Manual Del Usaurio página 18

OBJ_BUCH-0000000194-003.book Page 18 Friday, December 11, 2015 12:00 PM
en
18
Working instructions.
Before mounting or replacing cutting tool or accessories, pull the power plug.
WARNING
This preventive safety measure rules out the danger of injuries through acciden-
tal starting of the power tool.
For each job, use only the FEIN application tool released and intended for the respective
application.
Switching on and off (figure 6).
Check the power supply cable
WARNING
and the plug for damage.
Always hold the power tool
CAUTION
firmly. Otherwise, you could
lose control over the power tool.
Switching on:
Push the On/Off switch forward (I).
Switching off:
Press the switch downward ().
Securing the workpiece (figure 7).
Secure the workpiece sufficiently. An
inadequately secured workpiece can, for
example, cause the grinding accessory to
jam. This can lead to kickback, cause the
workpiece to fall down, and lead to
other dangerous situations.
Fig. 6
Fig. 7
On/Off switch