Battery Charging And Power Saving; Auto Power Off - Bowers & Wilkins PI3 Instrucciones De Funcionamiento

3. Battery Charging and Power Saving

Your PI3 comes with the battery partially charged
may be used immediately. For best practice we
recommend to fully charge the headphones before
first use. Please allow up to 3 hours for full charge.
The headphones can be used while charging.
To charge:
1. Please use the supplied charging cable and
connect the USB-A plug to a wall charger or a
powered computer USB-A socket.
2. Then connect the USB-C end to the
headphones USB-C socket
Note: During charging, the headphone indicator
will flash green. When fully charged, the indicator
will remain illuminated. See Diagram 3 for status
indicator details.

3.1 Auto Power Off

PI3 features smart power management. If no audio
is being streamed or played after 15 minutes, PI3 will
automatically disconnect Bluetooth and power down
to save battery life.
With the app, you can customise how long the
headphones will wait before auto power off, please
see Standby Timer under Settings in the app.
4. Wearing Your Headphones
Wearing your headphones correctly will help ensure
you get the best possible experience, see Diagram
5. Like many in-ear headphones, the PI3 earpieces
are designed to seal the ear canal in order to
perform optimally. The earpieces are also designed
be used with the stabiliser fins and must be installed
prior to use.
Both ear tips and stabiliser fins come in three sizes
(small, medium and large). Finding the proper size
for your ear is critical to obtaining a good seal and
ensure PI3 performs optimally.
1. Identify the left and right earpieces by finding
the identification legends located on the interior
of each cable near the earpieces. Hold PI3 by
the left and right control units and hang the
headphone around your neck comfortably, the
earpieces should be at equal length.
2. Place the earphones in your ear so that the
tips sit comfortably at the opening of the
ear canal.
3. Ensure the stabiliser fins are sitting comfortably
in the ear. Try another size if they do not fit.
Different sized ear tips and stabiliser fins can
be used to ensure the best possible fit.
R
Diagram 4
USB-C cable connection
R
Diagram 5
Wearing your headphones
L
4