Controls; Before Use - Beurer EM 38 Manual De Instrucciones

6. Controls

Part No. Description
1 On/off/pause button
2 Intensity adjustment
increase
decrease
3 Program/locking key
4 Battery compartment
5 Display with LCD display

7. Before Use

Putting on the belt
Before each use, ensure that your skin is clean and free of creams or oils.
1. Lay out the belt with the electrodes facing you.
2. Moisten the electrodes and your back with water. Ensure that the elec-
trode surfaces are moistened evenly to avoid localised voltage peaks
when they are applied to your skin.
3. Fit the belt around your waist so that the vertical seams A are at the
same place on each side of your body. The Beurer logo B is then in the
middle of the spinal column.
See the diagram
When positioned correctly, the electrodes C are slightly to the left
and right of your spinal column.
4. Then, close the fastener.
Ensure that the belt fits tightly enough to provide a good contact between the electrodes and your skin, but
does not constrict.
Part No. Description
6 Battery status, appears when batteries are depleted
7 Intensity, level 0 – 20
8 Pause symbol, flashes when activated
9 TIMER: Remaining time of the active program in
minutes
10 Keylock active
11 Active program
7
A
C
A
B