Beninca CP.J3 Manual Del Usuario página 10

Terminals Function
(1-2) Antenna
5 COM
6 Step by Step
7 STOP
8 PHOT
24VDC Motor
JP1/JP7
Encoder
14-15 Blinker
16-17 24 Vac
JP4 Secondary
J3 Radio Receiver
N.B.: To control the automation during installation, the Step by Step button on the control unit can be
used.
TCA
Adjustment of the automatic close time if enabled by Dip-Switch 1.
Adjustment ranges from 1 sec to max 90 sec
AMP-O
Adjustment of the amperometric sensor obstacle detection sensitivity during the open
cycle.
AMP-C Adjustment of the amperometric sensor obstacle detection sensitivity during the close
cycle.
Turn the trimmers clockwise (+) to increase the torque, turn them anticlockwise (-) to reduce
the torque.
Adjustment of trimmers AMP-O and AMP-C must comply with statutory regulations.
If an obstacle is detected:
When opening, the gate is stopped.
When closing, the gate stops and opens for about 3 sec.
10
Control units CP.J3
INPUT/OUTPUT FUNCTIONS
Description
Optional antenna connection to built-in radio receiver board (1-
signal/2-screen).
If external antenna connected cut wire welded to "ANT".
Common for all control inputs.
Step by step button input (N.O. contact)
STOP button input (N.C. contact)
Input for safety devices, N.C. contact (e.g. photocells)
In close cycle: if the contact opens, the motor will stop and will in-
stantly reverse direction (opening).
In open cycle: disabled.
IExtractable connector with connection to 24VDC + Encoder
A: + Encoder
B: S Encoder signal
C: - Encoder
Blinker connection, 24Vac/15W max.
Accessory power supply 24Vac/1A max.
IMPORTANT: If the battery charger board JM.CB is installed, the
output (without mains power connected) has a 24Vdc polarised
voltage. Make sure the devices are correctly connected.
(i.e. 16:+24Vdc - 17:-24Vdc).
Secondary circuit of the transformer.
18 Grey: 0V output
19 Red: Slowdown speed.
Connect the Faston to the 20V output
20 Brown: 24V output
21 White: Motor speed.
See section "Motor speed adjustment "
Built-in radio receiver
Trimmer functions