GreenWorks Pro BPB80L00 Manual Del Propietário página 12

ASSEMBLY
BATTERY
IMPORTANT! The battery pack is not charged when it is purchased. Before using the blower
for the first time, place the battery pack in the battery charger and charge. Make sure to read all
safety precautions, and follow the instructions in the Battery Charger section.
To Remove (See Fig 4.)
1. Press and hold the battery release button with firm grip.
2. Grasp the backpack firmly. Pull the battery pack out of the handle.
The battery pack fits into the backpack snugly in order to prevent accidental dislodging. It
NOTE:
may require a strong pull to remove it.
To Install (See Fig 4.)
1. Align the tongue of the battery pack with the cavity in the backpack housing.
2. Insert the battery into the battery opening until the battery release button locks into place.
3. Grasp the backpack firmly.
4. Push the battery pack into the backpack until both sides lock. The latch button will click
when locked into place.
5. Do not use force when inserting the battery pack. It should slide into place and click.
Battery Release
Button
W A R N I N G
Follow these instructions in order to avoid injury and to reduce the risk of electric shock or fire:
• Replace the battery pack or the charger immediately if the battery case or charger cord is
damaged.
• Verify that the switch is in the OFF position before inserting or removing the battery pack.
• Verify that the battery pack is removed and the switch is in the OFF position before inspecting,
adjusting, or performing maintenance on any part of the blower.
• Read, understand, and follow the instructions contained in the section entitled Charging Proce-
dure.
12
Fig. 4