AEG AHB93321LW Manual De Instrucciones página 13

Problem
The compressor operates
continually.
There is too much frost and
ice.
The compressor does not
start immediately after
pressing the FROSTMATIC,
or after changing the tem-
perature.
Temperature cannot be set.
The temperature in the ap-
pliance is too low/too high.
Possible cause
Temperature is set incorrect-
ly.
Large quantities of food to
be frozen were put in at the
same time.
The room temperature is too
high.
Food placed in the appli-
ance was too warm.
The lid is not closed proper-
ly.
The FROSTMATIC function
is switched on.
The lid is not closed correct-
ly or the gasket is deformed/
dirty.
The water drainage plug is
not correctly positioned.
Temperature is set incorrect-
ly.
This is normal, no error has
occurred.
The FROSTMATIC function
is switched on.
The temperature regulator is
not set correctly.
The lid is not closed correct-
ly.
The products' temperature
is too high.
Many products are stored at
the same time.
The thickness of the frost is
greater than 4-5 mm.
ENGLISH
Solution
Refer to "Operation" chap-
ter.
Wait some hours and then
check the temperature
again.
Refer to climate class chart
on the rating plate.
Allow food to cool to room
temperature before storing.
Check if the lid closes well
and the gaskets are undam-
aged and clean.
Refer to "FROSTMATIC
function".
Refer to "Opening and clos-
ing the lid".
Position the water drainage
plug in the correct way.
Refer to "Operation" chap-
ter.
The compressor starts after a
period of time.
Refer to "FROSTMATIC
function".
Set a higher/lower tempera-
ture.
Refer to "Opening and clos-
ing the lid".
Let the product temperature
decrease to room tempera-
ture before storage.
Store less products at the
same time.
Defrost the appliance.
13