Blue Clean 1700 PSI AR 240 S Instrucciones De Montaje, Cuidado Y Uso página 7

ASSEMBLY INSTRUCTIONS
3
4
J
D
Connect the other end of high pressure hose (D) to
spray gun (J) by inserting the brass metal tip of high
pressure hose into the fitting just ahead of trigger
guard. It will lock into spray gun with a "click". Confirm
hose is locked into spray gun by slightly pulling on them.
The hose is now securely attached to spray gun.
Note: DO NOT press button on underside of gun when
connecting hose to gun.
A
D
High Pressure Hose Assembly
Screw high pressure hose (D) clockwise onto bottom
front of power washer unit (A). Pull back collar and
insert o-ring post into water outlet far enough so
collar can thread onto outlet threads until hand tight.
If it takes fewer than six turns you have not properly
tightened the high pressure hose fitting. It is easier to
position the power washer in front of you to ensure that
the threads are started correctly. Failure to properly
tighten high pressure hose will result in the hose
slipping or popping off immediately upon turning unit
on. Do not worry about damage if this occurs–just
reinstall and take extra care when screwing on the high
pressure hose fitting.
Note: DO NOT use pliers or locking pliers to tighten.
5
J
D
To release hose (D) from spray gun (J), press button on
underside of gun toward trigger guard. The hose will
slide out from connection.
2
7